Blue Trail Engineering’s THR-100X High-efficiency Thruster is a game-changing solution for small Autonomous Surface Vehicles or Autonomous Underwater Vehicles requiring low power draw, high performance, and extreme reliability in the harsh ocean environment.
The THR-100X is built around a Swiss Maxon DC brushless motor designed to produce high torque at low RPM. Because of this, no gearbox is required, yielding higher efficiency, lower noise, and greater reliability than geared thrusters.
The brushless motor is coupled to the propeller magnetically: a ring of magnets mounted on the motor transmits torque to a matching ring of magnets mounted to the propeller shaft. The two sets of magnets are separated by a solid barrier, eliminating any potential for leakage and eliminating the drag inherent in traditional shaft seals. Thrust loads are supported with a corrosion-free ceramic ball bearing on the propeller shaft, producing drastically lower drag and wear than plastic bearings.
The THR-100X is rated to 300 m depth. Its housing consists of hard-anodized aluminum and acetal components with dual O-rings for reliable sealing.
An efficient, durable, fiber-reinforced propeller with 8-inch diameter and 6-inch pitch is standard on the THR-100X, but other sizes are available. Contact Blue Trail Engineering for assistance with choosing a propeller to maximize performance in your particular application.
A brushless motor controller (not included) should be housed external to the thruster and connected with a standard 3-wire connection. The THR-100X is available with two connection options: the Blue Trail Cobalt Series bulkhead connector or the SEACON MCBH-3M wet-mate bulkhead connector.
Environmental | |
Depth Rating | 300 meters |
Operating Temperature | 0° C to +50° C |
Motor | |
Motor Type | Maxon 634043 3-phase brushless inrunner |
Torque Constant | 0.115 Nm/A |
Speed Constant | 83 RPM/volt |
Maximum Voltage | 20 V |
Maximum Continuous Current | 5.4 A |
No-load Current | 0.4 A |
Number of Pole Pairs | 8 |
Materials | |
Housing | Hard-anodized aluminum, acetal |
Propeller Shaft | 316 stainless steel |
Propeller Shaft Bearing | Ceramic ball bearing |
Propeller | Fiber-reinforced plastic |
Size/Weight | |
Dimensions | 69.5 mm OD X 257 mm length |
Weight in Air | 2200 grams |
Weight in Water | 1400 grams |